The Ariens Ikon X 52 is a 52-inch zero-turn riding mower featuring a powerful engine, durable cutting deck, hydrostatic transmission, ergonomic controls, and high-back seat. This parts manual provides detailed diagrams, part numbers, and descriptions for all components to assist with maintenance, repair, and ordering of genuine Ariens replacement parts. Below are key sections for identification, diagrams, part lists, ordering information, and safety.
Locate your model and serial number to ensure correct parts ordering. The Ikon X 52 is available in multiple configurations.
| Location | Description |
|---|---|
| Model Number Plate | Located on the frame under the seat or on the rear fender |
| Serial Number | Stamped near the model plate; required for warranty claims |
| Engine Model & Code | Found on the engine shroud or valve cover |
| Deck Identification | 52-inch stamped steel deck with model-specific spindle assemblies |
Critical safety components and decals that must be maintained for safe operation.
WARNING! Never operate mower with missing or damaged safety parts. Replace immediately.
Complete breakdown of the 52-inch cutting deck components.
Parts for the engine and hydrostatic drive system.
Engine (Kawasaki/Briggs & Stratton variants): Air filter, spark plug, oil filter, fuel pump, carburetor kit, muffler, recoil starter.
Hydrostatic Transmission: Drive belt (part number 035-3579), pump filter, hydraulic oil, axle shafts, wheel motors.
Drive Pulleys & Idlers: Tensioner assemblies, idler arms, and springs.
Operator control components and comfort features.
Tip: Lubricate control linkages periodically for smooth operation.
Structural components and chassis parts.
| Component | Part Number | Description |
|---|---|---|
| Main Frame | 035-8000 | Welded steel frame assembly |
| Front Axle | 035-8001 | Pivot axle with bushings |
| Fender Set | 035-8002 | Left and right steel fenders |
| Foot Platform | 035-8003 | Rubber mat and plate |
| Rollover Protection (ROPS) | 035-8004 | Optional ROPS frame kit |
Wiring, switches, lights, and battery components.
CAUTION! Disconnect battery before servicing electrical components.
Front and rear wheel assemblies.
Common bolts, nuts, washers, and pins used throughout the mower.
Hardware Kit (035-9000): Includes assorted Grade 5 and Grade 8 bolts, lock nuts, washers, cotter pins, and hairpin clips.
Note: Always use genuine Ariens hardware for proper strength and fit.
Recommended service intervals and part replacements.
| Interval | Service | Parts Required |
|---|---|---|
| Every 25 hours | Check blade condition | Blades (035-9100) |
| Every 50 hours | Engine oil & filter change | Oil filter, drain plug gasket |
| Every 100 hours | Air filter replacement | Air filter element |
| Every 300 hours | Drive belt inspection | Deck belt (035-2468), Drive belt (035-3579) |
| Annually | Hydraulic fluid & filter | Hydro filter, hydraulic oil |
How to order genuine Ariens parts and warranty information.
Ordering: Use part numbers from this manual. Contact an authorized Ariens dealer or visit www.ariens.com. Provide model and serial number.
Warranty: Limited warranty applies to original owner. Keep proof of purchase. Damage from misuse, lack of maintenance, or non-genuine parts voids warranty.
Support: For technical assistance, call 1-800-678-5443 or email [email protected].