Ariens GRAVELY GR1332FX Lawn Mower Manual

The Ariens GRAVELY GR1332FX is a 32-inch zero-turn riding lawn mower featuring a 13.5 HP Briggs & Stratton engine, hydrostatic transmission, dual-lever steering control, 6-speed gearbox, electric start, 3-in-1 cutting system (mulch/bag/side discharge), adjustable cutting height (1.5" to 4.5"), heavy-duty steel deck, high-back seat with armrests, LED headlights, hour meter, and fuel gauge. Designed for residential and light commercial use. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly & Setup 3. Controls and Operation 4. Specifications 5. Cutting System 6. Maintenance Schedule 7. Storage & Winterization 8. Safety Features 9. Warranty Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 32-inch reinforced steel cutting deck, 13.5 HP engine, dual hydrostatic pumps, lap bar steering controls, 6-gallon fuel tank, adjustable seat, and LED lighting.

Feature	Description
Engine	13.5 HP Briggs & Stratton, 344cc, OHV, electric start
Cutting Width	32 inches
Transmission	Hydrostatic, dual-pump with wheel motors
Steering	Dual lap bar control for zero-turn operation
Cutting Height	6 positions, 1.5" to 4.5" adjustable via lever
Deck Material	12-gauge reinforced steel
Fuel Capacity	6 gallons
Seat	High-back with armrests, adjustable fore/aft
Lighting	LED headlights for low-light operation
Discharge Options	Mulch, bag, or side discharge (3-in-1)

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

Install steering lap bars: Attach to control panel with provided bolts.
Attach seat: Mount seat on sliding rail and secure with bolts.
Install battery: Connect red (+) then black (-) terminals; secure in tray.
Add engine oil: Use SAE 10W-30, fill to dipstick "Full" mark.
Add fuel: Use unleaded gasoline (87 octane minimum).
Check tire pressure: Inflate to 15 PSI (front) and 10 PSI (rear).

WARNING! Do not attempt to start engine before adding oil and fuel. Keep hands clear of moving parts during assembly.

Controls and Operation

Familiarize yourself with controls before operation.

Pre-start checklist: Check oil, fuel, tire pressure, and clear area of debris.
Starting: Sit on seat, engage parking brake, set throttle to "Fast", turn key to start.
Steering: Push both lap bars forward to move forward; pull back to reverse. For turns, move one bar slower than the other.
Cutting height: Adjust lever while deck is disengaged.
Engage blades: Pull PTO (Power Take-Off) lever to engage cutting blades.
Shutdown: Disengage PTO, set throttle to "Slow", turn key off, engage parking brake.

CAUTION! Always disengage blades when not cutting. Do not operate on slopes greater than 15 degrees.

Specifications

Model: Ariens GRAVELY GR1332FX
Engine: 13.5 HP Briggs & Stratton, 344cc, OHV
Cutting Width: 32 inches
Cutting Height Range: 1.5" - 4.5" (6 positions)
Transmission: Hydrostatic, dual-pump
Fuel Capacity: 6 gallons
Turning Radius: Zero-turn capability
Weight: 580 lbs (approx.)
Warranty: 3-year limited residential warranty

Cutting System

3-in-1 system allows mulching, bagging, or side discharge.

Mulching: Install mulch plug and mulching blade. Cuts clippings finely back into lawn.
Bagging: Attach grass bagger to rear chute. Empty bag when full.
Side Discharge: Remove mulch plug; attach discharge chute for ejection to side.
Blade Care: Sharpen blades every 25 hours; replace if bent or damaged.
Deck Cleaning: Clean underside after each use to prevent rust and buildup.

Tip: For best results, mow when grass is dry and never remove more than 1/3 of grass height at once.

Maintenance Schedule

Regular maintenance ensures longevity and performance.

Interval	Task
Before each use	Check oil level, tire pressure, fuel, and clear deck of debris
Every 8 hours	Check battery terminals; clean air pre-cleaner
Every 25 hours	Sharpen blades; check belt tension; grease fittings
Every 50 hours	Change engine oil; replace oil filter; check spark plug
Every 100 hours	Replace air filter; check transmission fluid
Seasonally	Replace fuel filter; inspect and replace belts if worn

WARNING! Always disconnect spark plug wire before performing maintenance.

Storage & Winterization

Proper storage prevents fuel system damage and corrosion.

Add fuel stabilizer to tank and run engine for 5 minutes.
Change engine oil and filter at end of season.
Remove battery, clean terminals, and store in cool, dry place on trickle charger.
Clean entire mower, especially underside of deck.
Store in dry, covered area; cover with breathable tarp.

CAUTION! Do not store with fuel in tank for more than 30 days without stabilizer.

Safety Features

Built-in safety systems to protect operator.

Operator Presence System (OPS): Engine shuts off if operator leaves seat with blades engaged.
Parking Brake: Must be engaged to start engine.
Blade Brake Clutch (PTO): Blades stop within 5 seconds of disengagement.
Reverse Caution Mode: Blades disengage automatically when traveling in reverse (can be overridden).
Rollover Protection System (ROPS): Reinforced frame design.

Always wear eye protection, hearing protection, and sturdy footwear while operating.

Warranty Information

Ariens GRAVELY GR1332FX includes a 3-year limited warranty for residential use (90 days commercial). Warranty covers defects in materials and workmanship. Not covered: normal wear, misuse, neglect, improper maintenance, or use of non-Ariens parts. Keep receipt and register product at www.ariens.com or www.gravely.com.

Regulatory Information

This product complies with ANSI/OPEI B71.1-2017 safety standards for ride-on mowers. Engine meets EPA Phase 3 emissions standards. Copyright © 2023 Ariens Company; Gravely is a registered trademark. For technical support, contact Ariens Customer Service at 1-800-678-5440 or visit www.ariens.com.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Dead battery, empty fuel, parking brake not engaged	Charge battery; add fuel; ensure parking brake is engaged; check spark plug.
Loss of power	Clogged air filter, old fuel, dirty carburetor	Replace air filter; drain old fuel; clean carburetor.
Uneven cut	Dull blades, uneven tire pressure, deck not level	Sharpen blades; adjust tire pressure; level deck.
Hydrostatic transmission sluggish	Low fluid, air in system	Check fluid level; purge air per manual.
Excessive vibration	Loose blade, damaged spindle, debris in deck	Tighten blade; inspect spindle; clean deck.

Service: For repairs, contact authorized Ariens/Gravely dealer. Use only genuine parts.

Support: 1-800-678-5440; www.ariens.com; www.gravely.com