The Ariens Deluxe 24 Model 921045 is a 24-inch two-stage snow thrower designed for heavy-duty snow removal. It features a 208cc Ariens AX engine, electric start (with included battery), power steering, 6 forward speeds and 2 reverse speeds, heated hand grips, LED headlights, and a durable steel auger and impeller. This manual covers safety, operation, maintenance, troubleshooting, and specifications to ensure proper use and longevity of your equipment.
Key components: 24-inch clearing width, Two-stage auger system, 208cc Ariens AX Engine, Electric Start with battery, Power Steering, 6 Forward/2 Reverse speeds, Heated Hand Grips, LED Headlights, Steel Auger with serrated edge, Drift Cutters, Skid Shoes.
| Feature | Description |
|---|---|
| Clearing Width | 24 inches for efficient snow removal |
| Engine | 208cc Ariens AX Engine, 4-cycle, OHV |
| Starting System | Electric start (battery included) and recoil backup |
| Drive System | Power steering for easy maneuverability |
| Speeds | 6 forward speeds, 2 reverse speeds |
| Comfort Features | Heated hand grips, LED headlights for visibility |
| Auger/Impeller | 12-inch steel auger, 14-inch steel impeller |
| Chute Control | Remote chute rotation and deflector adjustment |
| Skid Shoes | Adjustable for cutting height |
| Drift Cutters | For breaking through deep snow banks |
Read all instructions before operating. Wear appropriate safety gear.
WARNING! Risk of serious injury or death from rotating auger. Never attempt to clear clog by hand. Always use clearing tool. Disconnect spark plug before performing maintenance.
Unpack and inspect all parts. Assembly requires basic tools.
CAUTION! Ensure all bolts are tightened securely. Test controls for free movement before starting engine.
Control panel located on handle. Auger control lever (left), drive control lever (right), chute control knob, deflector control lever, ignition key, electric start button, headlight switch, heated grip switch.
Operation Steps: 1. Insert key. 2. Set choke (cold start). 3. Engage electric start or pull recoil. 4. Squeeze auger control to engage auger. 5. Squeeze drive control to move machine. 6. Adjust chute direction and deflector angle as needed.
Tips: Overlap each pass by a few inches. Take shallow cuts in deep snow. Allow machine to clear snow before advancing.
Electric Start: 1. Insert key and turn to ON. 2. Set choke to FULL (cold engine). 3. Press and hold electric start button until engine starts. 4. Gradually move choke to OFF position as engine warms.
Recoil Start (Backup): 1. Insert key, turn to ON. 2. Set choke. 3. Pull recoil starter cord briskly.
Stopping: 1. Release auger and drive controls. 2. Turn key to OFF. 3. Remove key. For emergency stop, turn key to OFF immediately.
WARNING! Never leave machine unattended with engine running. Always turn off and remove key.
| Interval | Task |
|---|---|
| Before each use | Check engine oil level, tire pressure, controls, and fasteners. |
| First 5 hours | Change engine oil (break-in). |
| Every season | Change engine oil, check spark plug, lubricate control cables and pivot points. |
| Every 25 hours | Change oil, check/replace spark plug, inspect shear pins and belts. |
| Every 50 hours | Change oil, replace spark plug, inspect friction disc, check tire wear. |
| As needed | Adjust skid shoes, replace shear pins, sharpen/scrape auger edge. |
Note: Use only Ariens genuine parts for replacement. Refer to parts diagram in manual.
Proper storage prevents fuel system issues and corrosion.
CAUTION! Gasoline left in carburetor over 30 days can form gums that clog fuel system. Use stabilizer or drain.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | No fuel, bad spark plug, choke setting, dead battery | Check fuel level, spark plug, choke position. Charge or replace battery. |
| Engine runs poorly | Old fuel, dirty air filter, clogged fuel line | Use fresh fuel. Clean/replace air filter. Inspect fuel line. |
| Auger won't turn | Shear pin broken, control cable loose | Replace shear pin (use only genuine parts). Adjust cable tension. |
| No drive/won't move | Drive control not engaged, friction disc worn, drive belt loose/broken | Engage control fully. Inspect friction disc and drive belt; replace if worn. |
| Excessive vibration | Damaged auger, loose bolts, foreign object in auger | Stop engine, inspect for damage/obstruction. Tighten all bolts. |
| Electric start not working | Dead battery, poor connection, faulty switch | Charge battery. Check terminals for corrosion. Test switch. |
Reset: For safety interlock issues, ensure all controls are in neutral/off position before starting.
Ariens Deluxe 24 Model 921045 is covered by a limited warranty. Residential use: 3-year warranty on entire machine, 5-year warranty on auger housing. Commercial use: 1-year warranty. Warranty covers defects in materials or workmanship. Not covered: normal wear, misuse, lack of maintenance, improper storage, use of non-genuine parts. Proof of purchase required. For warranty service, contact an authorized Ariens dealer.
Support: For technical assistance, parts, or dealer location, visit www.ariens.com or call 1-800-678-5443.